Hey Guys,
I've accepted the challenge of making an exact replica of the Tahoe for the Sheriff I work for. I need to figure out how to make the rear lighting system on the Tahoe.
Here is the back of the Tahoe.
https://www.bluefireflight.com/Police-V ... /i-jr7Hr3C
I need to know some good idea's on how to make the lights above the rear window and the light pods around the license plates.
I was thinking some evergreen plastic pieces, but I'm not sure how well that will look.
Any help would be great,
~Steven
I need Help....
I need Help....
Steven
Check Out My Photography Website Full of Police, Fire, And Aviation Pictures.
www.bluefireflight.com
Check Out My Photography Website Full of Police, Fire, And Aviation Pictures.
www.bluefireflight.com
Re: I need Help....
For my models in 1:43 scale, I use thin strips of Evergreen plastic. I run a black sharpie over the surfaces that wont be glued. When dry, I use my LED decals and place them one at a time. I cut really close to the decal, so not much clear overlaps the strip of plastic. Then I just glue them up under the visor. Here is one using a Ford, but it gives you the idea. I would do the same for a larger scale, just use bigger LED decals. I do the same for the LED lights near the license plate. I just use one decal, and use a razor blade to cut the plastic strips, then touch up with a new Sharpie.
- Attachments
-
- Chicago FD Interceptor 2.JPG (112.15 KiB) Viewed 1663 times
Administrator
Re: I need Help....
Thanks for the info Rich, I'll give it a try.
Steven
Check Out My Photography Website Full of Police, Fire, And Aviation Pictures.
www.bluefireflight.com
Check Out My Photography Website Full of Police, Fire, And Aviation Pictures.
www.bluefireflight.com
Who is online
Users browsing this forum: No registered users and 7 guests