The Scale Firehouse appears to have bitten the dust. The format was changed at the end of 2019 and there have been no new posts since November. So here's hoping some of the modelers who used SFH can find a new home here.
This is the latest in new builds. Mashpee on Cape Cod had this rig back in the late '60's and into the '90's. It is now a relic of the past but I thought it would be worth saving by modeling it.
- 002.JPG (452.26 KiB) Viewed 10677 times
In the photo above the tires have been cast from a 3D printed master from which a mold was made. The frame is from a Ford truck kit and the rear axle is from an Ertl kit.
- 035.JPG (429.72 KiB) Viewed 10677 times
The engine is from a 1941 Chevy pickup kit. IH had its own line of engines including what they called Red Diamond series. The Chevy engine was modified by cutting the transmission loose and attaching it to the other end of the block since the manifold and spark plugs are completely opposite on the IH engine to the Chevy. Fan belt pulleys are from a turned aluminum rod.
- 028.JPG (424.18 KiB) Viewed 10677 times
A look at the front hub parts that have been made from brass tubing and square stock. The wheels are held in place with the small screw which fits into the brass tubing. The shoulder of the screw is just large enough to prevent the wheel from sliding over it.
- 030.JPG (432.13 KiB) Viewed 10677 times
The cab is an Illini Replicas IH R190 resin casting. The hood was cut away revealing the thickness of the casting. It's not very good for attempting an opening hood so a replacement was made using sheet brass and a small piano hinge. I used the firewall from the Chevy kit and the fit was almost perfect except for small adjustments to the sides and upper corners. The resin firewall was just a plain piece that had no detail.
- 039.JPG (436.77 KiB) Viewed 10677 times
The tricky part was getting the accent line of the cab to follow through on the hood. That was the first step in the process. After that it was a matter of squaring up the resin casting at the grill and at the firewall. Then the brass hood was cut to shape after annealing to soften it some. Bending the brass is easier that way. Small bits of excess material were ground or filed away to get a reasonable fit. The inner fenders are pieces of soft aluminum sheet. They were shaped to fit and then holes were drilled into the edges and into the resin fenders. Common pins were inserted to hold the inner fenders in place. Then two part epoxy was used to secure the fit in-between the aluminum and resin. ACC does not like aluminum at all and would not have worked.
- 040.JPG (440.05 KiB) Viewed 10677 times
And that is where we are at this point. The small louvers till have to be added to the sides of the hood along with small pieces of brass stock to hold the hood in place at final assembly. Lots of material sources have been used in this build and there will be more as the construction progresses.
